How to Calculate Current Through a Proportional Valve

How to Calculate Current Through a Proportional Valve

There are a few ways to get around the problem of reading a proportional valve's resistance as it changes from 0-10v.proportional valve 0-10v The problem is that many people make the mistake of thinking that proportional resistance means a simple conversion from volts to amperes. This is not always the case, and there are other considerations that must be made in order to get the best results.

Do you know what this is? Well, it is the difference between your valve's input voltage and its output voltage.proportional valve 0-10v proportional valve 0-10v A "Resistance" for a valve is simply the difference between these two voltages, measured in ohms, and that is all it means. So, if you need to know the actual resistance of a valve then you must use something more than a small magnifying glass to read the resistance.

If you look at a valve and you want to find out what its output resistance is, you must adjust the regulator to a voltage that is at least a hundred times smaller than the input voltage.proportional valve 0-10v proportional valve 0-10v If this sounds complicated, it is! It is just a little change, that is all it takes to get the voltage right.

Remember the regulator is a very modern design, and you must use one that does not use any silicon. One good example of a good regulator is the Quartz-Royall Valve. This is an "all purpose" regulator. You can use it for a variety of purposes, like adjusting a valve's output voltage.

When you are changing the output voltage of a valve, you should make sure that you are taking into account the total resistance of the valve as well. If the regulator has adjustable resistors then you must adjust the regulator with the same resistors that you originally have on the board. The extra resistors can be placed anywhere on the board and will need to be adjusted separately, or as a group.

If you want to know how much current flow is being generated by a valve then you need to first measure the voltage on the power source. Then, you have to determine how many amps the valve has actually been producing. When you know the maximum output voltage of the valve, you can calculate the current capacity of the output voltage. This calculation is quite accurate and only needs to be done once per valve.

In order to determine the current flow with a proportional valve, you will need to measure the impedance at one of the valves' terminals. Make sure that you do not change the continuity checking circuit when you are doing this. Remember, it would ruin your PSU!

Proportional resistance is not a simple conversion between voltage and amperes, and it is not that hard to calculate either. However, if you want to know the actual current flowing through a valve then you must turn to some kind of solenoid switching regulator!

Tags:electric valve cr704 | electric valve cr502 | electric motor control valve with ss304 valve